G1/2 Water Flow Sensor Control Effect Flowmeter Switch 1-30L/min for Arduino

Description

Home
Arduino
Module
Sensor
Chips
About Us
Description:
100% brand new and high quality
The water flow sensor is applied for water heater, and can be used as flow switch.
Straight structure, nylon and glass fiber made, waterproof and explosion-proof, heat and cold resistant
Portable size and light weight, easy to install
With stainless steel ball inside of the impeller, wear-proof
Three wire connection: Red for positive, black for negative, yellow for pulse signal
Maximum water pressure: 1.75MPa
Working range: 1-30L/min
Size: Approx. 5.6*3.5*3.5cm (L*W*H)
External diameter: 1.9cm
Inner diameter: 1.1cm
Cable length: 10.5cm
Color: Black
Note
:
Avoid strong impact and chemical erosion;
Forbid to throw or collision;
Install vertically, angle of inclination should not be exceeded 5 degree
Medium temperature should not be exceeded 120℃
Package Include:
1 x Water Flow Sensor
Payment
Shipping
Refund
Payment
We accept PayPal only.
But we only
Accept
your
Ebay Address
,Please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
Shipping
Fill your shipping info
Refund
All package need to
wait 30 days
(US only n
eed 7-10 days)
,
Please take care it.Less than 30 days,we can't take a refund
.
If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.